Operation CHARM: Car repair manuals for everyone.

B1281




DTC Troubleshooting: B1281, B1282, B1283, B1284

DTC B1281:

Front Wiper MIST Position Circuit Malfunction

DTC B1282:

Front Wiper INT (AUTO) Position Circuit Malfunction

DTC B1283:

Front Wiper LOW Position Circuit Malfunction

DTC B1284:

Front Wiper HIGH Position Circuit Malfunction

NOTE: If you are troubleshooting multiple DTCs, be sure to follow the instructions in B-CAN System Diagnosis Test Mode A Troubleshooting - B-CAN System Diagnosis Test Mode A.

1. Clear the DTCs with the HDS.

2. Turn the ignition switch to LOCK (0) and then back to ON (II), or press the engine start/stop button to select the OFF mode and then the ON mode.

3. Turn the wiper switch to the MIST, INT, LOW, HIGH, and OFF positions, and wait for at least 6 seconds.

4. Check for DTCs with the HDS.

Are DTCs B1281, B1282, B1283, and/or B1284 indicated?

YES -

Go to step 5.

NO -

Intermittent failure, the wiper system is OK at this time. Check for loose or poor connections.�

5. Select WIPERS from the BODY ELECTRICAL menu, and enter DATA LIST.

6. Check each wiper switch position value with the DATA LIST menu.

When the wiper switch is turned OFF





Are all data list values correct?

YES -

Go to step 7.

NO -

Go to step 10.

7. Turn the ignition switch to LOCK (0), or press the engine start/stop button to select the OFF mode.

8. Disconnect driver's under-dash fuse/relay box connector R (24P).

9. Check for continuity between driver's under-dash fuse/relay box connector R (24P) terminals as shown:





Is there continuity?

YES -

Repair short between the wires.�

NO -

Faulty driver's MICU; replace the driver's under-dash fuse/relay box Drivers Under-Dash Fuse/Relay Box (Drivers MICU) Removal and Installation.�

10. Turn the ignition switch to LOCK (0), or press the engine start/stop button to select the OFF mode.

11. Disconnect the 8P connector from the wiper switch.

12. Turn the ignition switch to ON (II), or press the engine start/stop button to select the ON mode.

13. Check each wiper switch position value with the DATA LIST menu.





Are all data list values correct?

YES -

Replace the wiper/washer switch Service and Repair.�

NO -

Go to step 14.

14. Turn the ignition switch to LOCK (0), or press the engine start/stop button to select the OFF mode.

15. Disconnect driver's under-dash fuse/relay box connector R (24P).

16. Check for continuity between body ground and driver's under-dash fuse/relay box connector R (24P) terminals No. 15,No. 16, and No. 17 individually.





Is there continuity?

YES -

Repair a short to ground in the wire.�

NO -

Go to step 17.

17. Check for continuity between driver's under-dash fuse/relay box connector R (24P) terminal No. 4 and terminals No. 15,No. 16, and No. 17 respectively.





Is there continuity?

YES -

Repair a short between the wires.�

NO -

Faulty driver's MICU; replace the driver's under-dash fuse/relay box Drivers Under-Dash Fuse/Relay Box (Drivers MICU) Removal and Installation.�