Operation CHARM: Car repair manuals for everyone.

34-1x




SRS DTC Troubleshooting: 34-1x

DTC 34-1x ("x" can be 0 thru 9 or A thru F):

Open in the Right Side Curtain Airbag Inflator

Special Tools Required

- SRS Inflator Simulator 07SAZ-TB4011A
- SRS Simulator Lead L 070AZ-SNAA300

NOTE:

- Before doing this troubleshooting procedure, find out if the vehicle was in a collision. If so, verify that all the required components were replaced with new components, of the correct part number, and that they were properly installed Service and Repair.
- Before doing this troubleshooting procedure, review SRS Precautions and Procedures Service and Repair, General Troubleshooting Information Reading and Clearing Diagnostic Trouble Codes, and Battery Terminal Disconnection and Reconnection Procedures.
- Before replacing the SRS unit, check the SRS unit software version with the HDS. If the software version is not the latest, update the SRS unit software SRS Unit Update, and retest.

1. Clear the DTCs with the HDS.

2. Turn the ignition switch to ON (II), or press the engine start/stop button to select the ON mode, then wait for 10 seconds.

3. Check for DTCs with the HDS.

Is DTC 34-1x indicated?

YES -

Go to step 4.

NO -

Intermittent failure, the system is OK at this time. Go to Troubleshooting Intermittent Failures. If another DTC is indicated, troubleshoot the DTC.�

4. Turn the ignition switch to LOCK (0), or press the engine start/stop button to select the OFF mode.

5. Disconnect the negative cable from the battery, then wait at least 3 minutes.

6. Remove the right side C-pillar trim.

7. Disconnect the SRS floor wire harness 2P connector (A) from the right side curtain airbag 2P connector.





8. Connect the black terminal of SRS simulator lead L (B) to the SRS inflator simulator (2 Ohms connector), and then connect SRS simulator lead L to the SRS floor wire harness 2P connector.

9. Reconnect the negative cable to the battery.

10. Clear the DTCs with the HDS.

11. Turn the ignition switch to ON (II), or press the engine start/stop button to select the ON mode, then wait for 10 seconds.

12. Check for DTCs with the HDS.

Is DTC 34-1x indicated?

YES -

Go to step 13.

NO -

Open in the right side curtain airbag inflator; replace the right side curtain airbag Side Curtain Airbag Replacement, then clear the DTC.�

13. Turn the ignition switch to LOCK (0), or press the engine start/stop button to select the OFF mode.

14. Disconnect the negative cable from the battery, then wait at least 3 minutes.

15. Disconnect SRS unit connector B (39P) from the SRS unit.

16. Disconnect the SRS inflator simulator from SRS simulator lead L. Do not disconnect SRS simulator lead L from the SRS floor wire harness 2P connector.

17. Measure the resistance of the black SRS simulator lead L black terminal (A). There should be less than 1.0 Ohms.





Is the resistance as specified?

YES -

Faulty SRS unit or poor connection at SRS unit connector B (39P) and the SRS unit. Check the connection; if the connection is OK, replace the SRS unit SRS Unit Replacement. If the DTC does not clear, replace the harness.�

NO -

Open in the SRS floor wire harness; replace the SRS floor wire harness, then clear the DTC.�