84-01

VSA DTC Troubleshooting: 84-01

DTC 84-01:

VSA Sensor Neutral Position Not Written

1. Do the VSA sensor neutral position memorization Programming and Relearning.

2. Clear the DTC with the HDS.

3. Turn the ignition switch to LOCK (0), then turn it to ON (II) again, or select the OFF mode, then the ON mode.

4. Check for DTCs with the HDS.

Is DTC 84-01 indicated?

YES -

Go to step 5.

NO -

The system is OK at this time.�

5. Update the VSA modulator-control unit if it does not have the latest software Testing and Inspection. If the unit already has the latest software, substitute a known-good VSA modulator-control unit Service and Repair.

6. Turn the ignition switch to LOCK (0), then turn it to ON (II) again, or select the OFF mode, then the ON mode.

7. Check for DTCs with the HDS.

Is DTC 84-01 indicated?

YES -

Check for loose terminals in the VSA modulator-control unit 47P connector. If the VSA modulator-control unit was updated, substitute a known-good VSA modulator-control unit Service and Repair, then retest. If the VSA modulator-control unit was substituted, go to step 1.

NO -

If the VSA modulator-control unit was updated, troubleshooting is complete. If the VSA modulator-control unit was substituted, replace the original VSA modulator-control unit Service and Repair. If any other DTCs are indicated, go to the indicated DTCs troubleshooting.�