Manufacturer Code Charts: 86

VSA DTC Troubleshooting: 86

DTC 86:

F-CAN Communication Malfunction

NOTE: Troubleshoot fuel and emissions DTC's first.

1. Turn the ignition switch to ON (II), or press the engine start/stop button to select the ON mode.

2. Clear the DTC with the HDS.

3. Start and run the engine for at least 5 seconds.

4. Check for DTCs with the HDS.

Is DTC 86 indicated?

YES -

Go to step 5.

NO -

Check the COMMU FI ECU, COMMU A/T (A/T), COMMU GAUGE, COMMU YAW RATE/G, COMMU STEERING ANGLE S (With SH-AWD), and COMMU 4WD (With SH-AWD) in the VSA FREEZE DATA with the HDS. Then check for F-CAN communication lines continuity to the appropriate system or sensor and loose terminals in the appropriate system or sensor connectors.�

5. Check the COMMU FI ECU, COMMU A/T (A/T), COMMU GAUGE, COMMU YAW RATE/G, COMMU STEERING ANGLES (With SH-AWD), and COMMU 4WD (With SH-AWD) in the VSA DATA LIST with the HDS.

Is there a communication error in the system or sensor?

YES -

Go to step 6.

NO -

Go to step 15.

6. Turn the ignition switch to LOCK (0), or press the engine start/stop button to select the OFF mode.

7. Short the SCS line with the HDS.

8. Disconnect ECM/PCM connector A (49P) Service and Repair.

9. Disconnect the VSA modulator-control unit 47P connector.

10. Disconnect the gauge control module 32P connector Service and Repair.

11. Disconnect the yaw rate-lateral acceleration sensor 4P connector Service and Repair, or the yaw rate-lateral/longitudinal acceleration sensor 4P connector .

12. With SH-AWD: Disconnect the steering angle sensor 5P connector Service and Repair.

13. With SH-AWD: Disconnect SH-AWD control unit connector A (20P) .

14. Check the F-CAN communication lines for continuity between the VSA modulator-control unit and the appropriate system or sensor (see table).

With SH-AWD:

Do the F-CAN communication lines have continuity?

YES -

Go to step 15.

NO -

Repair an open in the appropriate wire.�

15. Check for loose terminals in the appropriate system or sensor connectors.

Are the appropriate system or sensor connectors OK?

YES -

Go to step 16.

NO -

Repair or reconnect the connector securely.�

16. Check for other system or sensor DTCs with the HDS.

Are there other DTCs indicated?

YES -

Do the appropriate DTC troubleshooting.�

NO -

Go to step 17.

17. Update the VSA modulator-control unit if it does not have the latest software Testing and Inspection. If the unit already has the latest software, substitute a known-good VSA modulator-control unit Service and Repair.

18. Start and run the engine for at least 5 seconds.

19. Check for DTCs with the HDS.

Is DTC 86 indicated?

YES -

Check for loose terminals in the VSA modulator-control unit 47P connector. If the VSA modulator-control unit was updated, substitute a known-good VSA modulator-control unit Service and Repair, then retest. If the VSA modulator-control unit was substituted, go to step 1.

NO -

If the VSA modulator-control unit was updated, troubleshooting is complete. If the VSA modulator-control unit was substituted, replace the original VSA modulator-control unit Service and Repair. If any other DTCs are indicated, go to the indicated DTCs troubleshooting.�