DTC Troubleshooting

DTC Troubleshooting: P062F, P062F

DTC P062F:

ECM/PCM Internal Control Module Keep Alive Memory (KAM) Error

NOTE: Before you troubleshoot, record all freeze data and any on-board snapshot, and review the general troubleshooting information Initial Inspection and Diagnostic Overview.

1. Turn the ignition switch to ON (II), or press the engine start/stop button to select the ON mode.

2. Clear the DTC with the HDS.

3. Check for Pending or Confirmed DTCs with the HDS.

Are any Pending or Confirmed DTCs indicated?

YES -

Go to step 4.

NO -

Intermittent failure, the system is OK at this time.�

4. Update the ECM/PCM if it does not have the latest software ECM/PCM Update, or substitute a known-good ECM/PCM.

5. Check for Pending or Confirmed DTCs with the HDS.

Is DTC P062F indicated?

YES -

If the ECM/PCM was updated, substitute a known-good ECM/PCM, then recheck. If the ECM/PCM was substituted, go to step 1.

NO -

If the ECM/PCM was updated, troubleshooting is complete. If the ECM/PCM was substituted, replace the original ECM/PCM Service and Repair. If any other Pending or Confirmed DTCs are indicated, go to the indicated DTC's troubleshooting.�