Power Mirror Actuator Test

Power Mirror Actuator Test

1. Remove the door panel Front Door Panel Removal/Installation.

2. Disconnect the 13P connector (A) from the power mirror (B).






3. At the 13P connector, check the actuator operation by connecting power and ground according to the table.

Power Mirror Actuator





4. If the mirror fails to work properly, check for an open in the wire between the connector and the mirror holder. If the wire is OK, replace the mirror actuator.

Defogger Test

5. Check for continuity between terminals No. 5 and No. 10 of the 13P connector. There should be continuity.

6. If there is no continuity, check for an open in the wire between the connector and the mirror holder. If the wire is OK, replace the mirror holder Mirror Holder Replacement.