Instrument Cluster / Carrier: Service and Repair

Gauge Control Module Replacement

NOTE: Before replacing the gauge control module, retrieve the ODO value and the maintenance minder information from the gauge control module with the HDS Programming and Relearning.

1. Remove the driver's dashboard undercover Driver's Dashboard Undercover Removal/Installation, then remove the dashboard lower cover Driver's Dashboard Lower Cover Removal/Installation.

2. Remove the two bolts from under the dashboard, then pull the gauge control module (A) out carefully.





3. Disconnect the 32P connector (B) from the gauge control module.

4. Install the gauge control module in the reverse order of removal.

5. Rewriting the ODO data and transfer the maintenance minder data to a new gauge control module Programming and Relearning.