DTC Troubleshooting

DTC Troubleshooting: P0706

DTC P0706:

Open in Transmission Range Switch Circuit

NOTE:

- Before you troubleshoot, record all freeze data and any on-board snapshot with the HDS, and review the General Troubleshooting Information How to Troubleshoot the A/T System.
- This code is caused by an electrical circuit problem and cannot be caused by a mechanical problem in the transmission.

1. Make sure the shift cable is adjusted properly Adjustments.

2. Turn the ignition switch to ON (II).

3. Compare the ATPP, ATPR, ATPN, ATPD, ATPS, ATPFWD, and ATPRVS inputs with the HDS to the following table, in each shift lever position.









Do the transmission range switch signals match?

YES -

Intermittent failure, the system is OK at this time.�

NO -

Go to step 4.

4. Compare the ATPP, ATPR, ATPN, ATPD, ATPS, ATPFWD, and ATPRVS inputs with the HDS to the table in step 3, in each shift lever position.

Do all shift positions remain OFF?

YES -

Go to step 12.

NO -

Record any input that did not correctly indicate ON, then go to step 5.

5. Turn the ignition switch to LOCK (0).

6. Disconnect the transmission range switch connector.

7. Connect the transmission range switch connector terminal which did not indicate ON in step 4 to body ground with a jumper wire.

8. Turn the ignition switch to ON (II).

9. Check the transmission range switch signal that did not indicate ON with the HDS.

Does the transmission range switch indicate ON?

YES -

Replace the transmission range switch Service and Repair.�

NO -

Go to step 10.

10. Turn the ignition switch to LOCK (0).

11. Check for continuity between the transmission range switch circuit terminal and the PCM terminal of the input which indicated OFF. Refer to the following table.





Is there continuity?

YES -

Update the PCM if it does not have the latest software PCM Update. If the PCM was updated, replace the PCM Service and Repair.�

NO -

Repair an open in the wire between the transmission range switch and the PCM.�

12. Turn the ignition switch to LOCK (0).

13. Disconnect the transmission range switch connector.

14. Check for continuity between transmission range switch connector terminal No. 6 and body ground.





Is there continuity?

YES -

Replace the transmission range switch Service and Repair.

NO -

Repair an open in the wire between the transmission range switch and body ground (G101), or repair poor body ground (G101).�