Driver's Power Seat Motor Test

Driver's Power Seat Motor Test

NOTE: SRS components are located in this area. Review the SRS component locations Locations, and precautions and procedures Service and Repair before doing repairs or servicing.

1. Remove the driver's seat Front Seat Removal/Installation.

2. Disconnect the 5P connector from each power seat motor.

NOTE: All connectors are terminal side of male terminals.










3. Test each motor by connecting power and ground according to the table. When the motor stops running, disconnect battery power immediately.





4. If the motor does not run or fails to run smoothly, replace:

- Slide motor Front Seat Slide Motor Replacement
- Front up-down motor Front Seat Up-Down Motor Replacement
- Rear up-down motor
- Recline motor Front Seat Recline Motor Replacement