Front Seat Lumbar Support Replacement

Front Seat Lumbar Support Replacement

SRS components are located in this area. Review the SRS component locations Locations and the precautions and procedures Service and Repair before doing repairs or service.

NOTE:

- Put on gloves to protect your hands.
- Take care not to kink the cable.
- Take care not to tear or damage the seat covers.

1. Remove the driver's seat Front Seat Removal/Installation.

2. Remove the seat-back cover/pad Front Seat-Back Cover Replacement.

3. Remove the cable clamp (A) fastening the lumbar support cable (B).






4. Remove the screws securing the lumbar support actuator (A).






5. Remove the lumbar support (A).

1. While pulling the lower part of the lumbar support to one side of the seat back frame, release it from the lower wire (B).

2. Release an opposite side of the lumbar support from the other lower wire.

3. Release the upper part of the lumbar support from both upper springs (C).





6. Release the lower wires (A) from both active head restraint links (B).





7. Install the lumbar support in the reverse order of removal.