Interior Light Switch Test/Replacement

Interior Light Switch Test/Replacement

NOTE: The interior light switch is built into the moonroof switch.

1. Remove the front individual map lights Service and Repair.

2. Disconnect the moonroof switch 12P connector (A) and the map light 3P connector (B).





3. Remove the moonroof switch (C) from the map light housing.

4. At the moonroof switch side, check for continuity between terminals No. 9 and No. 7.

- There should be continuity when the interior light switch is in the DOOR position.
- There should be no continuity when the interior light switch is in the OFF position.

5. If the continuity is not as specified, replace the moonroof switch assembly.

6. Install the parts in the reverse order of removal.