B1152

DTC Troubleshooting: B1152

DTC B1152:

Gauge Control Module (EEPROM) Error

NOTE: If you are troubleshooting multiple DTCs, be sure to follow the instructions in B-CAN System Diagnosis Test Mode A Troubleshooting - B-CAN System Diagnosis Test Mode A.

1. Clear the DTCs with the HDS.

2. Turn the ignition switch to LOCK (0) and then back to ON (II), or press the engine start/stop button to select the OFF mode and then the ON mode.

3. Wait for at least 6 seconds.

4. Check for DTCs with the HDS.

Is DTC B1152 indicated?

YES -

Replace the gauge control module Service and Repair.�

NO -

Intermittent failure, the system is OK at this time.�