B1231

DTC Troubleshooting: B1231 (G and AUTO)

DTC B1231 or DTC indicator G and AUTO:

An Open in the Evaporator Temperature Sensor Circuit

1. Clear the DTC with the HDS.

2. Turn the ignition switch to LOCK (0), and then back to ON (II), or press the engine start/stop button to select the OFF mode, and then the ON mode.

3. Do the Self-Diagnostic Function with the HDS or the climate control unit.

4. Check for DTCs.

Is DTC B1231 or G and AUTO indicated?

YES -

Go to step 5.

NO -

Intermittent failure. Check for loose wires or poor connections on the evaporator temperature sensor circuit.�

5. Turn the ignition switch to LOCK (0), or press the engine start/stop button to select the OFF mode.

6. Disconnect climate control unit connector C (20P).

7. Disconnect the evaporator temperature sensor 2P connector.

8. Check for continuity between climate control unit connector C (20P) terminal No. 16 and evaporator temperature sensor 2P connector terminal No. 1.





Is there continuity?

YES -

Go to step 9.

NO -

Repair an open in the wire between the climate control unit and the evaporator temperature sensor.�

9. Check for continuity between climate control unit connector C (20P) terminal No. 1 and evaporator temperature sensor 2P connector terminal No. 2.





Is there continuity?

YES -

Go to step 10.

NO -

Repair an open in the wire between the climate control unit and the evaporator temperature sensor.�

10. Remove the evaporator temperature sensor Service and Repair, and test it Evaporator Temperature Sensor Test.

Is the evaporator temperature sensor OK?

YES -

Check for loose wires or poor connections at climate control unit connector C (20P) and at the evaporator temperature sensor 2P connector. If the connections are good, substitute a known-good climate control unit, and recheck. If the symptom/indication goes away, replace the original climate control unit Service and Repair.�

NO -

Replace the evaporator temperature sensor Service and Repair.�