Manufacturer Code Charts: 1301

Navigation System DTC Troubleshooting: 1301

DTC 1301:

GPS Antenna Error

NOTE:

- Check the vehicle battery condition first Battery Test.
- This navigation DTC sets when there is poor connectors or loose terminals at the GPS antenna connector or an open in GPS antenna lead.
- Check any official Honda service website for more service information about the navigation system.
- Before you troubleshoot, make sure to follow the General Troubleshooting Information How To Troubleshoot The Navigation System.
- Make sure the vehicle is parked outside, away from buildings.
- Aftermarket electronic devices located near the audio-navigation unit or GPS antenna can potentially interfere with the operation of the navigation system.

1. Clear the hard error code.

2. Turn the ignition switch to LOCK (0) , or press the engine start/stop button to select the OFF mode.

3. Turn the ignition switch to ON (II), or press the engine start/stop button to select the ON mode, and wait at least 1 minute.

4. Check for the hard error code.

Is DTC 1301 indicated?

YES -

Go to step 5.

NO -

Intermittent failure, the system is OK at this time.�

5. Turn the ignition switch to LOCK (0), or press the engine start/stop button to select the OFF mode.

6. Check for poor connections or loose terminals at audio-navigation unit connector J (2P).

Are the connections OK?

YES -

Replace the GPS Antenna Service and Repair.�

NO -

Repair poor connections or loose terminals, and recheck. If the code continues to reset intermittently, replace the GPS antenna Service and Repair.�