44-11

SH AWD DTC Troubleshooting: 44-11

DTC 44-11:

SH-AWD Control Unit

NOTE: Before you troubleshoot, review the general troubleshooting information Initial Inspection and Diagnostic Overview.

1. Turn the ignition switch to ON (II), or press the engine start/stop button to select the ON mode.

2. Clear the DTC with the HDS.

3. Turn the ignition switch to LOCK (0), then turn the ignition switch back to ON (II), or select the OFF mode, then the ON mode.

4. Check for DTCs with the HDS.

Is DTC 44-11 indicated?

YES -

Update the SH-AWD control unit if it does not have the latest software SH-AWD Control Unit Update, or substitute a known-good SH-AWD control unit Service and Repair, and recheck. If the symptom/indication goes away with the updated SH-AWD control unit, troubleshooting is complete. If the symptom/indication goes away with a known-good SH-AWD control unit, replace the original SH-AWD control unit Service and Repair.�

NO -

Intermittent failure, the system is OK at this time.�