49-1

SH AWD DTC Troubleshooting: 49-1

DTC 49-1:

SH-AWD Control Unit (PG Line Open)

NOTE: Before you troubleshoot, review the general troubleshooting information Initial Inspection and Diagnostic Overview.

1. Turn the ignition switch to ON (II), or press the engine start/stop button to select the ON mode.

2. Clear the DTC with the HDS.

3. Start the engine.

4. Check for DTCs with the HDS.

Is DTC 49-1 indicated?

YES -

Go to step 5.

NO -

Intermittent failure, the system is OK at this time.�

5. Turn the ignition switch to LOCK (0), or press the engine start/stop button to select the OFF mode.

6. Disconnect SH-AWD control unit connector B (8P).

7. Check for continuity between SH-AWD control unit connector terminal B2 and body ground.





Is there continuity?

YES -

Update the SH-AWD control unit if it does not have the latest software SH-AWD Control Unit Update, or substitute a known-good SH-AWD control unit Service and Repair, and recheck. If the symptom/indication goes away with the updated SH-AWD control unit, troubleshooting is complete. If the symptom/indication goes away with a known-good SH-AWD control unit, replace the original SH-AWD control unit Service and Repair.�

NO -

Repair an open in the wire between SH-AWD control unit connector terminal B2 and body ground, or repair poor body ground at G604.�