Manufacturer Code Charts: 60

Adaptive Cruise Control (ACC) DTC Troubleshooting: 60

DTC 60:

F-CAN A Communication error

1. Check the MIL on the gauge control module Initial Inspection and Diagnostic Overview.

Does the MIL stay on?

YES -

Go to the PGM-FI system's general troubleshooting information Initial Inspection and Diagnostic Overview.�

NO -

Go to step 2.

2. Clear the DTCs with the HDS Reading and Clearing Diagnostic Trouble Codes.

3. Press the engine start/stop button to select the ON mode, then wait for 10 seconds.

4. Press the MAIN switch ON.

5. Check for DTCs with the HDS Reading and Clearing Diagnostic Trouble Codes.

Is DTC 60 indicated?

YES -

Go to step 6.

NO -

Intermittent failure, the system is OK at this time.�

6. Press the engine start/stop button to select the OFF mode.

7. Disconnect the ACC unit 20P connector.

8. Measure the resistance between ACC unit 20P connector terminals No. 10 and No. 20. There should be less than 70 Ohms.





Is the resistance as specified?

YES -

Faulty ACC unit; replace the ACC unit Service and Repair.�

NO -

Repair an open in the wire between the ACC unit and the branch of the F-CAN A line (F-CAN A H,F-CAN A L).�