DTC Troubleshooting

DTC Troubleshooting: P0369

DTC P0369:

CMP Sensor Circuit Intermittent Interruption

NOTE: Before you troubleshoot, record all freeze data and any on-board snapshot, and review the general troubleshooting information Initial Inspection and Diagnostic Overview.

1. Turn the ignition switch to ON (II), or press the engine start/stop button to select the ON mode.

2. Clear the DTC with the HDS.

3. Start the engine, and let it idle for 10 seconds.

4. Check the CMP B NOISE in the DATA LIST with the HDS.

Are 0 counts indicated?

YES -

Go to step 7.

NO -

Go to step 5.

5. Test-drive the vehicle for several minutes in the range of these recorded freeze data parameters:

- ENGINE SPEED
- VSS

6. Check the CMP B NOISE in the DATA LIST with the HDS.

Are 0 counts indicated?

YES -

Go to step 7.

NO -

Intermittent failure, the system is OK at this time. Check for poor connections or loose terminals at the CMP sensor and the PCM.�

7. Check for poor connections or loose terminals at these locations:

- CMP sensor
- PCM
- Engine ground
- Body ground

Are the connections and terminals OK?

YES -

Go to step 8.

NO -

Repair the connections or the terminals, then go to step 11.

8. Check for damage to the front camshaft pulley (CMP pulse plate) Service and Repair.

Is the pulse plate damaged?

YES -

Replace the front camshaft pulley (CMP pulse plate) Service and Repair, then go to step 11.

NO -

Go to step 9.

9. Turn the ignition switch to LOCK (0), or press the engine start/stop button to select the OFF mode.

10. Replace the CMP sensor Service and Repair.

11. Turn the ignition switch to ON (II), or press the engine start/stop button to select the ON mode.

12. Reset the PCM with the HDS.

13. Do the PCM idle learn procedure PCM Idle Learn Procedure.

14. Start the engine, and let it idle for 10 seconds.

15. Check for Pending or Confirmed DTCs with the HDS.

Is DTC P0369 indicated?

YES -

Check for poor connections or loose terminals at the CMP sensor and the PCM, then go to step 1.

NO -

Troubleshooting is complete. If any other Pending or Confirmed DTCs are indicated, go to the indicated DTC's troubleshooting.�