DTC Troubleshooting

DTC Troubleshooting: P060A

DTC P060A:

PCM Internal Control Module Malfunction

NOTE: Before you troubleshoot, record all freeze data and any on-board snapshot, and review the general troubleshooting information Initial Inspection and Diagnostic Overview.

1. Turn the ignition switch to ON (II), or press the engine start/stop button to select the ON mode.

2. Clear the DTC with the HDS.

3. Check for Pending or Confirmed DTCs with the HDS.

Is DTC P060A indicated?

YES -

Go to step 4.

NO -

Intermittent failure, the system is OK at this time.�

4. Update the PCM if it does not have the latest software PCM Update, or substitute a known-good PCM.

5. Check for Pending or Confirmed DTCs with the HDS.

Is DTC P060A indicated?

YES -

If the PCM was updated, substitute a known-good PCM, then recheck. If the PCM was substituted, go to step 1.

NO -

If the PCM was updated, troubleshooting is complete. If the PCM was substituted, replace the original PCM Service and Repair. If any other Pending or Confirmed DTCs are indicated, go to the indicated DTC's troubleshooting.�