Advanced Diagnostics

Advanced Diagnostics - DTC P0731: Problem in 1st Clutch and 1st Clutch Hydraulic Circuit










General Description
To engage 1st gear, line pressure is supplied to the 1st clutch piston, engaging the 1st clutch, and the secondary shaft and the secondary shaft 1st gear are connected and revolve together. Hydraulic pressure is supplied to the 1st clutch through the ATF strainer --> the ATF pump --> the main regulator valve --> the manual valve --> the shift valves --> the feed pipe --> the 1st clutch piston. (A shift valve failure in the supply route above is detected by the malfunction detection of each shift solenoid valve.) The powertrain control module (PCM) computes the ratio of the input shaft (mainshaft) speed to the output shaft (countershaft) speed. When the ratio is not the 1st gear ratio, the PCM detects a malfunction of the hydraulic circuit or the 1st clutch and stores a DTC.

Monitor Execution, Sequence, Duration, DTC Type, OBD Status






Enable Conditions






Malfunction Threshold
The actual gear ratio must match one of these conditions for at least 12 seconds with the 1st gear shift command:
- Actual gear ratio is greater than the 1st gear ratio by a factor of 1.25.
- Actual gear ratio is less than the 1st gear ratio by a factor of 0.8.

Driving Pattern
1. Start the engine.
2. Drive the vehicle at a speed of 8 mph (12 km/h) or more for at least 12 seconds in 1st gear.

- Drive the vehicle in this manner only if the traffic regulations and ambient conditions allow.

Diagnosis Details

Conditions for setting the DTC
When a malfunction is detected during the first drive cycle, a Pending DTC is stored in the PCM memory. If the malfunction returns in the next (second) drive cycle, a Confirmed DTC and the freeze data are stored. The MIL does not come on.

Conditions for clearing the DTC
The Pending DTC, the Confirmed DTC, and the freeze data can be cleared with the scan tool Clear command or by disconnecting the battery.