P2A03

DTC Troubleshooting: P2A00, P2A03

DTC P2A00:

Rear A/F Sensor (Bank 1, Sensor 1) Circuit Range/Performance Problem

DTC P2A03:

Front A/F Sensor (Bank 2, Sensor 1) Circuit Range/Performance Problem

NOTE:

- Before you troubleshoot, record all freeze data and any on-board snapshot, and review the general troubleshooting information Initial Inspection and Diagnostic Overview.
- Information marked with an asterisk (*) applies to the front bank (Bank 2).

1. Turn the ignition switch to ON (II), or press the engine start/stop button to select the ON mode.

2. Clear the DTC with the HDS.

3. Start the engine. Hold the engine speed at 3,000 rpm without load (in P or N) until the radiator fan comes on, then let it idle.

4. Test-drive under these conditions:

- Engine coolant temperature (ECT SENSOR 1) above 158 °F (70 °C)
- Transmission in D
- Vehicle speed between 25-55 mph (40-88 km/h) for 5 minutes.
- Drive at a steady speed between 55-75 mph (88-120 km/h) for 10 seconds, then decelerate (with the throttle fully closed) for at least 6 seconds.

5. Monitor the OBD STATUS for DTC P2A00 and/or P2A03* in the DTCs MENU with the HDS.

Does the HDS indicate FAILED?

YES -

Go to step 6.

NO -

If the HDS indicates PASSED, intermittent failure, the system is OK at this time. Check for poor connections or loose terminals at the A/F sensor (Sensor 1) and the PCM. If the HDS indicates EXECUTING, keep driving until a result comes on. If the HDS indicates OUT OF CONDITION, go to step 3 and recheck.

6. Turn the ignition switch to LOCK (0), or press the engine start/stop button to select the OFF mode.

7. Replace the A/F sensor (Sensor 1) A/F Sensor Replacement.

8. Turn the ignition switch to ON (II), or press the engine start/stop button to select the ON mode.

9. Reset the PCM with the HDS.

10. Do the PCM idle learn procedure PCM Idle Learn Procedure.

11. Test-drive under these conditions:

- Engine coolant temperature (ECT SENSOR 1) above 158 °F (70 °C)
- Transmission in D
- Vehicle speed between 25-55 mph (40-88 km/h) for 5 minutes.
- Drive at a steady speed between 55-75 mph (88-120 km/h) for 10 seconds, then decelerate (with the throttle fully closed) for at least 6 seconds.

12. Check for Pending or Confirmed DTCs with the HDS.

Is DTC P2A00 and/or P2A03* indicated?

YES -

Check for poor connections or loose terminals at the A/F sensor (Sensor 1) and the PCM, then go to step 1.

NO -

Go to step 13.

13. Monitor the OBD STATUS for DTC P2A00 and/or P2A03* in the DTCs MENU with the HDS.

Does the HDS indicate PASSED?

YES -

Troubleshooting is complete. If any other Pending or Confirmed DTCs were indicated in step 12, go to the indicated DTC's troubleshooting.�

NO -

If the HDS indicates FAILED, check for poor connections or loose terminals at the A/F sensor (Sensor 1) and the PCM, then go to step 1. If the HDS indicates EXECUTING, keep driving until a result comes on. If the HDS indicates OUT OF CONDITION, go to step 11.