U1289

DTC Troubleshooting: U1289

DTC U1289:

Gauge Control Module Lost Communication With Remote Slot Control Unit

NOTE: If you are troubleshooting multiple DTCs, be sure to follow the instructions in B-CAN System Diagnosis Test Mode A Troubleshooting - B-CAN System Diagnosis Test Mode A.

1. Clear the DTCs with the HDS.

2. Press the engine start/stop button to select the OFF, ACC, ON, and OFF mode.

3. Wait for at least 6 seconds.

4. Check for DTCs with the HDS.

Is DTC U1289 indicated?

YES -

Go to the remote slot control unit input test, and do all power, ground, and communication input tests. If the tests prove OK, replace the remote slot control unit.�

NO -

Intermittent failure, the system is OK at this time. Check for loose or poor connections at the remote slot control unit 40P connector and the related units.�