Center Console Panel Removal/Installation

Center Console Panel Removal/Installation

Special Tools Required

- KTC Trim Tool Set SOJATP2014
*Available through the Acura Tool and Equipment Program; call 888-424-6857

NOTE:

- Take care not to scratch the console.
- Use the appropriate tool from the KTC trim tool set to avoid damage when removing components.
- When prying with a flat-tip screwdriver, wrap it with protective tape to prevent damage.

1. Remove the driver's inner dashboard trim Driver's Inner Dashboard Trim Removal/Installation.

2. Remove the passenger's dashboard trim Passenger's Dashboard Trim Removal/Installation.

3. Apply protective tape (A) to the console panel along the side edge of the shift lever boot base (B). Pry up on the edge of the shift lever boot base with a flat-tip screwdriver to release the hooks (C).






4. Pull out the center console panel (A) to detach the clips (B, C). Disconnect the accessory power socket connector (D) and the seat heater switch connectors (E), then remove the panel.





5. Install the panel in the reverse order of removal, and note these items:

- If the clips are damaged or stress-whitened, replace them with new ones.
- Make sure each connector is plugged in properly.
- Push the clips into place securely.