Mirror Holder Replacement

Mirror Holder Replacement

NOTE:

- Put on gloves to protect your hands.
- When prying with a flat-tip screwdriver, wrap it with protective tape to prevent damage.

1. Carefully push on the top edge of the mirror holder (A) by hand.





2. Put a shop towel in the opening between the bottom edge of the mirror holder and the mirror housing (B) to prevent scratches. Insert a flat-tip screwdriver under the mirror holder, and detach the lower clips (C).

3. Carefully pull out the bottom edge of the mirror holder (A), and then release the upper clips (B).





4. Separate the mirror holder from the inner holder (C) on the actuator, and disconnect the mirror defogger connectors (D).

5. Before reinstalling the mirror holder to the inner holder (A) on the actuator, check the actuator rods (B) and the actuator boots (C).

NOTE: Make sure each actuator rod is inserted into the actuator securely, and each actuator boot is fully seated on the actuator.





6. Reconnect the mirror defogger connectors.

7. Reattach the hooks on the mirror holder to the actuator, then position the mirror holder on the actuator. Carefully push on the clip areas of the mirror holder until the mirror holder locks into place.

8. Check the actuator operation.