ACC Activation Indicator Does Not Come On
Adaptive Cruise Control (ACC) Symptom Troubleshooting - ACC activation indicator does not come on
ACC activation indicator does not come on
1. Do the gauge control module self-diagnostic function Initial Inspection and Diagnostic Overview.
Is the gauge control module OK?
YES -
Go to step 2.
NO -
Substitute a known-good gauge control module, and recheck. If the problem goes away, replace the original gauge control module Service and Repair.�
2. Test the MAIN switch Adaptive Cruise Control (ACC) Combination Switch Test.
Is the switch OK?
YES -
Go to step 3.
NO -
Replace the ACC combination switch Adaptive Cruise Control (ACC) Combination Switch/Distance Switch Removal/Installation.�
3. Press the engine start/stop button to select the ON mode.
4. Measure the voltage between cable reel connector C (20P) terminal No. 7 and body ground. There should be about 5 V.
Is the voltage as specified?
YES -
Repair an open in the wire between the ACC combination switch and body ground.�
NO -
Repair an open in the wire between the ACC combination switch and the gauge control module.�