Warm Up TWC Removal/Installation
Warm Up TWC Removal/Installation
FRONT WU-TWC (Bank 2)
1. Remove the No. 2 the ignition coil and the ignition coil heat insulator.
2. Remove the front A/F sensor (Sensor 1) and front secondary HO2S (Sensor 2).
3. Remove exhaust pipe A Service and Repair.
4. Remove the EGR pipe Service and Repair.
5. Remove the A/C condenser fan assembly Radiator and A/C Condenser Fan, Motor, and Shroud Removal and Installation and the radiator upper bracket/cushion.
6. Remove the front WU-TWC bracket, then carefully remove the front WU-TWC.
7. Carefully install the front WU-TWC with a new gasket and new self-locking nuts. Tighten the nuts in a crisscross pattern in two or three steps.
8. Install the parts in the reverse order of removal.
REAR WU-TWC (Bank 1)
1. Remove the rear A/F sensor (Sensor 1) and rear secondary HO2S (Sensor 2).
2. Remove exhaust pipe A Service and Repair.
3. Remove the intermediate shaft Intermediate Shaft Removal.
4. Remove the rear WU-TWC bracket, then carefully remove the rear WU-TWC.
5. Carefully install the rear WU-TWC with a new gasket and new self-locking nuts. Tighten the nuts in a crisscross pattern in two or three steps.
6. Install the parts in the reverse order of removal.