A/T Housing Third Shaft Bearing Removal

A/T Housing Third Shaft Bearing Removal

Special Tools Required

- Oil Seal Driver Attachment, 71.5 mm 07GAD-SE00100
- Driver Handle, 15 x 135L 07749-0010000

1. Remove the reverse idler gear assembly A/T Housing Reverse Idler Gear Removal/Installation.

2. To remove the third shaft bearing, expand the snap ring using snap ring pliers, then push the bearing out using the 15 x 135L driver handle and the 71.5 mm oil seal driver attachment. Do not remove the snap ring unless it is necessary to clean the groove in the transmission housing.