A/T Idler Gear Shaft Reassembly

A/T Idler Gear Shaft Reassembly

1. Install the idler gear (A) over the idler gear shaft (B).






2. Place the idler gear (A) on press bases (B), and place a spacer (C) between the idler gear shaft (D) and the press to prevent damaging the idler gear shaft.





3. Install the idler gear using a press.

4. Install the 32.5 mm cotter (A), the cotter retainer (B), and the snap ring (C) on the idler gear shaft (D).





5. Install the 27.5 x 41 x 2.5 mm thrust needle bearing (E) and the 41.5 mm washer (F).