Torque Converter Housing Countershaft Bearing Replacement

Torque Converter Housing Countershaft Bearing Replacement

Special Tools Required

- Bearing Driver Attachment, 72 x 75 mm 07746-0010600
- Adjustable Bearing Puller, 25-40 mm 07736-A01000B
- Driver Handle, 15 x 135L 07749-0010000
- Slide Hammer 07936-371020A
- Bearing Remover Shaft 07JAC-PH80200

1. Remove the countershaft bearing from the torque converter housing using the 25-40 mm adjustable bearing puller, the bearing remover shaft, and the slide hammer.






2. Check the ATF guide plate (A), and replace it if it is damaged.





3. Install a new bearing (B) in the direction shown.

4. Drive the bearing (A) in the torque converter housing using the 15 x 135L driver handle and the 72 x 75 mm attachment; install the bearing outer notch-cut (B) to a depth (C) of 0-0.14 mm (0-0.0055 in) below the torque converter housing surface (D).