Manufacturer Code Charts: 1301

Navigation System DTC Troubleshooting: 1301

DTC 1301:

GPS Antenna Error

NOTE:

- Check the vehicle battery condition first Battery Test.
- This navigation DTC sets when there is poor connectors or loose terminals at the GPS antenna connector or an open in GPS antenna lead.
- Check any official Honda service website for more service information about the navigation system.
- Before you troubleshoot, make sure to follow the General Troubleshooting Information How to Troubleshoot the Navigation System.
- Make sure the vehicle is parked outside, away from buildings.
- Aftermarket metallic window tint or electronic devices located near the navigation unit or GPS antenna can potentially interfere with the operation of the navigation system.

1. Clear the hard error code.

2. Turn the ignition switch to LOCK (0) and then back to ON (II).

3. Check for the hard error code.

Is DTC 1301 indicated?

YES -

Go to step 4.

NO -

Intermittent failure, the system is OK at this time. If the vehicle repeatedly comes back with the navigation DTC, replace the navigation unit Service and Repair.

4. Turn the ignition switch to LOCK (0).

5. Check for poor connections or loose terminals at navigation unit connector E (2P).

6. Clear the hard error code.

7. Turn the ignition switch to LOCK (0) and then back to ON (II).

8. Check for the hard error code.

Is DTC 1301 indicated?

YES -

Replace the GPS Antenna Service and Repair, and recheck. If the DTC does not clear, replace the navigation unit Service and Repair.

NO -

Intermittent failure, the system is OK at this time. If the vehicle repeatedly comes back with the navigation DTC, replace the navigation unit Service and Repair.