86-17

VSA DTC Troubleshooting: 86-17

DTC 86-17:

F-CAN Communication With ACC Unit Malfunction

NOTE:

- Troubleshoot any fuel and emissions DTCs first.
- Before you troubleshoot, record all freeze data and any on-board snapshot, and review the general troubleshooting information Reading and Clearing Diagnostic Trouble Codes.

1. Turn the ignition switch to ON (II).

2. Clear the DTC with the HDS.

3. Turn the ignition switch to LOCK (0) and then back to ON (II).

4. Check for DTCs with the HDS.

Is DTC 86-17 indicated?

YES -

If DTC 86-11 is indicated at the same time, do the DTC 86-11 troubleshooting first 86-11. If DTC 86-11 is not indicated, go to step 5.

NO -

If any other DTCs are indicated, go to the indicated DTCs troubleshooting. If DTCs are not indicated, intermittent failure, the system is OK at this time. Refer to intermittent failures troubleshooting.

5. Turn the ignition switch to LOCK (0) and then back to ON (II).

Do the ACC indicator come on then go off?

YES -

Go to step 6.

NO -

Do the ACC system troubleshooting Reading and Clearing Diagnostic Trouble Codes.

6. Turn the ignition switch to LOCK (0).

7. Disconnect ACC unit 20P connector Service and Repair.

8. Disconnect the VSA modulator-control unit 36P connector Service and Repair.

9. Check for continuity between the VSA modulator-control unit 36P connector terminal and the ACC unit 20P connector terminal (see table).









Is there continuity?

YES -

Check for loose terminals in the ACC unit 20P connector . If necessary, substitute a known-good ACC unit Service and Repair, then go to step 1 and recheck. If no DTCs are indicated, replace the original ACC unit Service and Repair. If DTC 86-17 resets, go to step 10.

NO -

Repair an open in the wire between the ACC unit and the VSA modulator-control unit.

10. Reconnect all connectors.

11. Update the VSA modulator-control unit if it does not have the latest software Testing and Inspection.

12. Turn the ignition switch to LOCK (0) and then back to ON (II).

13. Check for DTCs with the HDS.

Is DTC 86-17 indicated?

YES -

Check for loose terminals in the VSA modulator-control unit 36P connector. If the VSA modulator-control unit was updated and the symptom/indication is still present, replace the VSA modulator-control unit Service and Repair, then retest.

NO -

Troubleshooting is complete. If any other DTCs are indicated, go to the indicated DTCs troubleshooting.