Advanced Diagnostics

Advanced Diagnostics - DTC P2255: Front Air/Fuel Ratio (A/F) Sensor (Bank 2, Sensor 1) VS Circuit Low Voltage






General Description
The front air/fuel ratio (A/F) sensor (bank 2, sensor 1) is installed in the exhaust manifold and detects oxygen content in the exhaust gas. The front A/F sensor transmits a signal to the powertrain control module (PCM), and it enables overall feedback control. The PCM controls fuel injection duration by comparing the target air/fuel ratio with the front A/F sensor signal. When the self diagnosis function in the PCM detects a short circuit failure, it measures the PCM input voltage of the VSB2/VCENTB2/IPB2. If the VSB2 terminal voltage is less than VCENTB2/IPB2 terminal voltage, the PCM detects a malfunction and stores a DTC.

Monitor Execution, Sequence, Duration, DTC Type, OBD Status






Enable Conditions






Malfunction Threshold
The VSB2 terminal voltage is less than VCENTB2/IPB2 terminal voltage after the self diagnosis function in the PCM detects a short circuit failure for at least 0.5 second.

Driving Pattern
Start the engine. Hold the engine speed at 3,000 rpm without load (in P or N) until the radiator fan comes on, then let it idle for 2 minutes.

Diagnosis Details

Conditions for setting the DTC
When a malfunction is detected during the first drive cycle, a Pending DTC is stored in the PCM memory. If the malfunction returns in the next (second) drive cycle, the MIL comes on and a Confirmed DTC and the freeze data are stored.

Conditions for clearing the DTC
The MIL is cleared if the malfunction does not return in three consecutive trips in which the diagnostic runs. The MIL, the Pending DTC, the Confirmed DTC, and the freeze data can be cleared with the scan tool Clear command or by disconnecting the battery.