Instrument Fascia Removal / Installation

Instrument Fascia Removal/Installation

Special Tools Required

- KTC Trim Tool Set SOJATP2014
*Available through the Acura Tool and Equipment Program; 888-424-6857

NOTE:

- Use the appropriate tool from the KTC trim tool set to avoid damage when removing components.
- Take care not to scratch the dashboard or the panels.

1. Adjust the steering column to the full tilt down position, and the full telescopic out position.

2. Remove the instrument fascia (A).

1. Gently pull out the bottom portion of the instrument fascia to detach the clips (B, C).

2. Disconnect the dash lights brightness controller connector (D) and CMBS OFF/VSA OFF/AFS OFF switch connector (E).





3. Install the instrument fascia in the reverse order of removal, and note these items:

- If the clips are damaged or stress-whitened, replace them with new ones.
- Make sure each connector is plugged in properly.
- Push the clips into place securely.