Power Mirror Actuator Test

Power Mirror Actuator Test

NOTE: The power mirror actuator can be tested by using the HDS and following these steps:

- Enter BODY ELECTRICAL, then select POWER SEAT/POWER MIRROR from the BODY ELECTRICAL SYSTEM SELECT menu with the HDS.
- Select FUNCTIONAL TESTS from the TEST MODE MENU with the HDS, then do the appropriate power mirror function test.

1. Remove the front door sash inner trim Front Door Sash Inner Trim Replacement, and the door panel Front Door Panel Removal/Installation.

2. Disconnect the 16P connector (A) from the power mirror (B).






3. Check actuator operation by connecting power and ground according to the table.

Power Mirror Actuator





Retract Actuator





4. If the mirror fails to work properly, replace the appropriate actuator.

Defogger Test

5. Measure the resistance between power mirror 16P connector terminals No. 15 and No. 14. There should be about 8 Ohms or less.

- If the resistance is not as specified, check for an open or high resistance in the circuit.
- If there is no open circuit and the harness is OK, replace the mirror holder Power Mirror Actuator Replacement.