Moonroof Closing Force and Opening Drag Check

Moonroof Closing Force and Opening Drag Check

1. Remove the headliner Service and Repair.

2. Open the moonroof half-way.

3. Closing force check:

- Cover the leading edge of the glass (A) with a shop towel (B), and attach a spring scale (C) as shown.
- Have an assistant hold the switch to close the glass while you measure the force required to stop it.
- Read the force as soon as the glass stops moving, then immediately release the switch and the spring scale.









4. If the force in not within specification, remove the moonroof motor Service and Repair, and check the following items:

- Check the gear teeth and the inner cable for breakage and damage. If the gear teeth are broken, replace the motor. If the inner cable is damaged, remove the frame Service and Repair, and replace the cable Moonroof Drain Channel Slider and Cable Assembly Replacement.
- Check the moonroof motor for damage, and do the moonroof control unit input test Moonroof Control Unit Input Test. If the motor is damaged, fails to run, or does not turn smoothly, replace it.
- Check the opening drag. Go to step 5.

5. Opening drag check: Protect the leading edge of the glass with a shop towel (A). Measure the effort required to open the glass using a spring scale (B) as shown.





6. If the load is over 40 N (4 kgf, 9 lbf), check:

- The side clearance and glass position adjustment Adjustments.
- For broken or damaged sliding parts. If any sliding parts are damaged, replace them.

7. Do the moonroof control unit resetting procedure Testing and Inspection after reinstalling the moonroof motor.