Component Tests and General Diagnostics

Seat Ventilation Switch Test/Replacement

1. Remove the center console panel Center Console Removal / Installation.

2. Disconnect the 14P connector from the seat ventilation switch (A).





3. Remove the two screws and the switch.

4. Check for continuity between the terminals in each switch position according to the table.

NOTE:

- Make sure the correct test lead (+ or -) is placed on the terminal.
- When checking for continuity across the diode, use the diode setting () on the digital volt/ohm meter to check the diode bias.
- Be careful of this characteristic; a diode is one that conducts fully in one direction (forward) and not at all in the opposite direction (reverse).





5. If the continuity is not as specified, replace the seat ventilation switch.

6. Install the parts in the reverse order of removal.