Expansion Valve: Service and Repair

Evaporator Expansion Valve Replacement

1. Recover the refrigerant with a recovery/recycling/charging station A/C Refrigerant Recovery.

2. Remove the engine cover Service and Repair.

3. Remove the bolt, then disconnect the A/C lines (A) from the evaporator core.





4. Remove the blower unit Blower Unit Removal/Installation.

5. Remove the self-tapping screws and the expansion valve cover (A), then remove the bolts and the pipe/expansion valve (B) without bending the lines.






6. Remove the seals (A), the bolts, the O-rings (B), and the expansion valve (C) without bending the lines.





7. Install the valve in the reverse order of removal, and note these items:

- Replace the O-rings with new ones at each fitting, and apply a thin coat of refrigerant oil before installing them. Be sure to use the correct O-rings for HFC-134a (R-134a) to avoid leakage.
- Immediately after using the oil, reinstall the cap on the container, and seal it to avoid moisture absorption.
- Do not spill the refrigerant oil on the vehicle; it may damage the paint; if the refrigerant oil contacts the paint, wash it off immediately.
- Make sure that there is no air leakage.
- Charge the system A/C System Charging.