HID Lamp System Troubleshooting
HID Lamp System Troubleshooting
WARNING
A transient high tension (25,000 V) occurs at the bulb sockets of the high intensity discharge (HID) lamps when the combination light switch is turned ON, that may cause serious electrical shock or electrocution if you do not observe the cautions.
CAUTION
- Never turn on the combination light switch before fitting the HID bulbs to their bulb sockets and completing the reassembly of the headlight assembly.
- Do not service the headlights assembly in wet conditions, such as rain or snow, near a sprinkler system, or when your hands are wet to prevent electrocution.
- Do not touch the surface of the HID bulbs with your bare hands and do not stain it with any oils and fats.
- Do not disassemble the inverter unit and the igniter unit.
- Do not turn on the HID bulb by using a power source other than the battery mounted on the vehicle.
Special Tools Required
- HID Bulb Test Light 07AAJ-S3MA100
1. Check the No. 1 (15 A) and No. 6 (15 A) fuses in the under-hood fuse/relay box.
Are the fuses OK?
YES -
Go to step 2.
NO -
Replace the fuse(s), and recheck. If the fuse is blown again, repair a short in the wire.
2. Turn the combination light switch to OFF.
3. Do the battery terminal disconnection procedure.
4. Remove the bulb socket from the HID bulb Exterior Lights Bulb Replacement.
5. Check for corrosion and traces of electrical arcing on the contacts of the socket (A).
Is the socket corroded or burnt?
YES -
Replace the socket, and recheck.
NO -
Go to step 6.
6. Connect the HID bulb test light assembly (A) to the bulb socket (B).
7. Do the battery terminal reconnection procedure.
8. Turn the combination light (headlight) switch to ON.
Does the HID test light bulb come on?
YES -
Replace the original HID bulb Exterior Lights Bulb Replacement.
NO -
Go to step 9.
9. Measure the voltage between HID unit 2P connector terminal No. 2 and body ground.
Is there battery voltage?
YES -
Go to step 10.
NO -
Repair open or high resistance in the YEL or GRN wire.
10. Turn the combination light (headlight) switch to OFF.
11. Do the battery terminal disconnection procedure.
12. Remove the HID bulb test light assembly from the bulb socket.
13. Disconnect the HID unit 2P connector.
14. Do the battery terminal reconnection procedure.
15. Check for continuity between HID unit 2P connector terminal No. 1 and body ground.
Is there continuity?
YES -
Replace the HID unit.
NO -
Repair open high resistance in the wire between the HID unit and body ground. If the wire is OK, check for poor ground (G201, G301).
NOTE: Do the battery terminal reconnection procedure. Do steering column position memorization Programming and Relearning, and enter the anti-theft codes for the navigation system.