Side Airbag Replacement

Side Airbag Replacement

NOTE: If replacing the side airbag after deployment, refer to Component Replacement/Inspection After Deployment Service and Repair for a complete list of other parts that must also be replaced.

Removal

1. Do the battery terminal disconnection procedure, then wait at least 3 minutes before starting work.

2. Disconnect the side airbag inflator 2P connector (A).






3. Remove the seat Front Seat Removal / Installation and seat-back cover Service and Repair.

NOTE: If you are replacing a deployed airbag, replace the airbag attachment wire B (A).





4. Remove the mounting nuts (B) and the side airbag (C).

Installation

NOTE:

- If the side airbag lid is secured by a tape, remove the tape.
- Do not open the lid on the side airbag cover.
- Use new mounting nuts tightened to the specified torque.
- Make sure that the seat-back cover is installed properly. Improper installation may prevent proper deployment.
- Be sure to install the harness so that it is not pinched or interfering with other parts.

1. Place the side airbag on the seat-back frame (A). Torque the new side airbag mounting nuts (B).





2. Install the seat-back cover in the reverse order of removal Service and Repair.

NOTE: If you are replacing a deployed airbag, replace the airbag attachment wire B (C).

3. Install the seat Front Seat Removal / Installation, then connect the side airbag harness 2P connector.

4. Move the front seat and the seat-back through their full ranges of movement, making sure the harness wires are not pinched or interfering with other parts.

5. Do the battery terminal reconnection procedure.

6. Clear any DTCs with the HDS.

7. After installing the side airbag, confirm proper system operation: Turn the ignition switch to ON (II), and check that the SRS indicator should come on for about 6 seconds and then go off.