Rear Seat Belt Replacement

Rear Seat Belt Replacement

Rear Seat Belt

NOTE:

- Put on gloves to protect your hands.
- Take care not to tear or damage the seat covers.
- Check the rear seat belts for damage Testing and Inspection, and replace them if necessary.

1. Remove the rear seat cushion Rear Seat Removal / Installation.

2. Remove the lower anchor bolt (A).





3. Remove the rear seat-back Rear Seat Removal / Installation.

4. Remove the C-pillar trim from both sides.

5. Remove the rear shelf Service and Repair.

6. Remove the retractor mounting ET screw (A) and the retractor bolt (B), then remove the rear seat belt assembly (C).





7. Install the seat belt in the reverse order of removal, and note these items:

- Apply medium strength liquid thread lock to the anchor bolts before reinstallation.
- Check that the retractor locking mechanism functions.
- Before installing the anchor bolt, make sure there are no twists or kinks in the seat belt.
- Tighten the bolts by hand first, then tighten to the specified torque.

Center Seat Belt and Seat Belt Buckles

NOTE:

- Put on gloves to protect your hands.
- Take care not to tear or damage the seat covers.
- Check the center seat belt for damage Testing and Inspection, and replace it if necessary.

1. Remove the rear seat cushion Rear Seat Removal / Installation.

2. Remove the center anchor bolts (A), then remove the seat belt buckles (B) and the center seat belt buckle (C).






3. Release the lock washer (A), then remove the anchor bolt (B), the spring washer (C), the center seat belt (retractor anchor) (D), or the center seat belt buckle (buckle anchor), and the seat belt buckle (E).

NOTE: The retractor anchor is shown; the center seat belt buckle anchor is similar.





4. Remove the rear seat-back Rear Seat Removal / Installation.

5. Remove the C-pillar trim from both sides.

6. Remove the rear shelf Service and Repair.

7. Remove the retractor mounting ET screw (A) and the retractor bolt (B), then remove the rear seat belt assembly (C).






8. Remove the rear center seat belt protector (A).






9. Install the seat belt and the buckles in the reverse order of removal, and note these items:

- Apply medium strength liquid thread lock to the anchor bolts before reinstallation.
- Tighten the bolts by hand first, then tighten to the specified torque.
- Check that the retractor locking mechanism functions.
- Assemble the washers on the retractor bolt as shown.
- Before installing the center anchor bolt, make sure there are no twists or kinks in the center seat belt.

Retractor bolt installation