Drivers Under-Dash Fuse/Relay Box (MICU) Removal/Installation

Driver's Under-Dash Fuse/Relay Box (MICU) Removal/Installation

Special Tools Required

- Relay Puller 07AAC-000A2A1 or 07AAC-000A1A0

NOTE: SRS components are located in this area. Review the SRS component locations Locations, and precautions and procedures Service and Repair before doing repairs or servicing.

Removal

1. Do the battery terminal disconnection procedure.

2. Remove the left front door sill trim and left kick panel Service and Repair.

3. Disconnect the connectors from the fuse side of the driver's under-dash fuse/relay box (A).

NOTE: If necessary, remove the parking brake pedal assembly to make space.





4. Remove the mounting bolt, release the tab (B) and pull the driver's under-dash fuse/relay box away from the body.

5. Disconnect the connectors and remove the driver's under-dash fuse/relay box.

6. Carefully remove the relays by prying under the base of relay Testing and Inspection.

NOTE: Do not use pliers. Pliers will damage the relays, which could cause the engine to stall or not start or cause other functions to fail.

Installation

1. Install the relays and connect the connectors to the driver's under-dash fuse/relay box, then install the driver's under-dash fuse/relay box in the reverse order of removal.

2. Install the removed parts in the reverse order of removal.

3. Do the battery terminal reconnection procedure.

4. Confirm that all systems work properly.