A/T Clutch Clearance Inspection

A/T Clutch Clearance Inspection

Special Tools Required

- Clutch Compressor Attachment 07ZAE-PRP0100

1. Set a dial indicator (A) on the clutch end-plate (B).





2. Zero the dial indicator with the clutch end-plate lifted up to the snap ring (C).

3. Release the clutch end-plate to lower it, then put the clutch compressor attachment on the end-plate (A).





4. Press the clutch compressor attachment down with 147.1 N (15.00 kgf, 33.07 lbf) (B) using a force gauge or equivalent, and read the dial indicator (C).

5. The dial indicator reads the clearance (D) between the clutch end-plate and the top disc (E). Take measurements in at least three places, and use the average as the actual clearance.





6. If the measurement is out of the standard, replace the clutch assembly.