Power Rear Window Sunshade Switch Test

Power Rear Window Sunshade Switch Test

1. Remove the roof console Roof Console Replacement.

2. Disconnect the 28P connector (A) from the roof console (B).






3. Check for continuity between the terminals in each switch position according to the table.

NOTE:

- Make sure the correct test lead (+ or -) is placed on the terminal.
- When checking for continuity across the diode, use the diode setting () on the digital volt/ohm meter to check the diode bias.
- Be careful of this characteristic; a diode is one that conducts fully in one direction (forward) and not at all in the opposite direction (reverse).





4. If the continuity is not as specified, replace the roof console Roof Console Replacement.