118-1

VSA DTC Troubleshooting: 118-1

DTC 118:

Clutch Pedal Position Switch B Malfunction

NOTE: Before you troubleshoot, record all freeze data and any on-board snapshot, and review the general troubleshooting information Reading and Clearing Diagnostic Trouble Codes.

1. Turn the ignition switch to ON (II), or press the engine start/stop button to select the ON mode.

2. Clear the DTC with the HDS.

3. Turn the ignition switch to LOCK (0), or press the engine start/stop button to select the OFF mode.

4. Start and run the engine for at least 5 seconds.

5. Check for DTCs with the HDS.

Is DTC 86 indicated?

YES -

Do the troubleshooting for DTC 86 86-1.

NO -

Go to step 6.

6. Check for fuel and emissions systems DTCs with the HDS Initial Inspection and Diagnostic Overview.

Is DTC P0835 indicated?

YES -

Do the troubleshooting for DTC P0835 DTC Troubleshooting.

NO -

Go to step 7.

7. Check the CRUISE CANCEL CLUTCH SWITCH STATUS in the VSA DATA LIST with the HDS while moving the clutch pedal.

Does it indicate OFF when the pedal is pressed, and ON when the pedal is released?

YES -

Intermittent failure, the system is OK at this time. Refer to intermittent failures troubleshooting.

NO -

Go to step 8.

8. Turn the ignition switch to LOCK (0), or press the engine start/stop button to select the OFF mode.

9. Check the clutch pedal position switch B Clutch Pedal Position Switch B Test (M/T).

Is the clutch pedal position switch B OK?

YES -

Go to step 10.

NO -

Replace the clutch pedal position switch B Clutch Pedal Position Switch B Replacement (M/T).

10. Short the SCS line with the HDS.

11. Disconnect ECM connector A (49P) Service and Repair.

12. Disconnect the clutch pedal position switch B 3P connector.

13. Check for continuity between clutch pedal position switch B 3P connector terminal No. 2 and ECM connector A (49P) terminal No. 47.





Is there continuity?

YES -

Go to step 14.

NO -

Repair an open in the wire between the ECM and the clutch pedal position switch B.

14. Update the VSA modulator-control unit if it does not have the latest software Testing and Inspection.

15. Turn the ignition switch to LOCK (0), or press the engine start/stop button to select the OFF mode.

16. Test-drive the vehicle at 19 mph (30 km/h) or more.

NOTE: Drive the vehicle on the road, not on a lift.

17. Check for DTCs with the HDS.

Is DTC 118 indicated?

YES -

Check for loose terminals in the VSA modulator-control unit 47P connector. If the VSA modulator-control unit was updated and the symptom/indication is still present, replace the VSA modulator-control unit Service and Repair.

NO -

If the VSA modulator-control unit was updated, troubleshooting is complete. If any other DTCs are indicated, go to the indicated DTCs troubleshooting.