Manufacturer Code Charts: 1302

Navigation System DTC Troubleshooting: 1302

DTC 1302:

GPS Receiver Error 1

NOTE:

- Check the vehicle battery condition first Battery Test.
- This navigation DTC sets when there is an internal GPS receiver problem.
- Before you troubleshoot, make sure to follow the General Troubleshooting Information How to Troubleshoot the Navigation System.
- Make sure the vehicle is parked outside, away from buildings.
- Aftermarket metallic window tint or electronic devices located near the audio-navigation unit or GPS antenna can potentially interfere with the operation of the navigation system.

1. Clear the hard error code.

2. Turn the ignition switch to LOCK (0), or press the engine start/stop button to select the OFF mode, then back to ON (II), or press the engine start/stop button to select the ON mode.

3. Check for the hard error code.

Is DTC 1302 indicated?

YES -

Go to step 4.

NO -

Intermittent failure, the system is OK at this time. If the unit repeatedly comes back with the navigation DTC, replace the audio-navigation unit Audio-Navigation Unit Removal/Installation.

4. Turn the ignition switch to LOCK (0), or press the engine start/stop button to select the OFF mode.

5. Disconnect and reconnect audio-navigation unit connector J (2P).

6. Clear the hard error code.

7. Turn the ignition switch to LOCK (0), or press the engine start/stop button to select the OFF mode, then back to ON (II), or press the engine start/stop button to select the ON mode.

8. Check for the hard error code.

Is DTC 1302 indicated?

YES -

Replace the GPS Antenna Service and Repair, then recheck. If the navigation DTC continues to set, replace the audio-navigation unit Audio-Navigation Unit Removal/Installation.

NO -

Intermittent failure, the system is OK at this time. If the vehicle repeatedly comes back with the navigation DTC, replace the audio-navigation unit Audio-Navigation Unit Removal/Installation.