Hazard Warning Switch Test/Replacement

Hazard Warning Switch Test/Replacement

1. Remove the dashboard center vent Dashboard Center Vent Removal/Installation.

2. Push out the hazard warning switch (A) from behind the dashboard center vent.





3. Disconnect the 6P connector (B) from the hazard warning switch.

4. Check for continuity between the terminals in each switch position according to the table.

NOTE:

- Make sure the correct test lead (+ or -) is placed on the terminal.
- When checking for continuity across the diode, use the diode setting () on the digital volt/ohm meter to check the diode bias.
- Be careful of this characteristic; a diode is one that conducts fully in one direction (forward) and not at all in the opposite direction (reverse).





5. If the continuity is not as specified, replace the hazard warning switch.

6. Install the switch in the reverse order of removal.