12-1
VSA DTC Troubleshooting: 12, 14, 16, 18
DTC 12:
Right-Front Wheel Speed Sensor Signal Malfunction
DTC 14:
Left-Front Wheel Speed Sensor Signal Malfunction
DTC 16:
Right-Rear Wheel Speed Sensor Signal Malfunction
DTC 18:
Left-Rear Wheel Speed Sensor Signal Malfunction
NOTE:
- Before you troubleshoot, record all freeze data and any on-board snapshot, and review the general troubleshooting information Reading and Clearing Diagnostic Trouble Codes.
- If the ABS and the VSA indicators come on because of electrical noise, the indicator goes off when you test-drive the vehicle at 9 mph (15 km/h) after the system returns to normal.
1. Turn the ignition switch to LOCK (0), or press the engine start/stop button to select the OFF mode.
2. Check that the appropriate wheel speed sensor is properly mounted Service and Repair.
Is the wheel speed sensor installation OK?
YES -
Go to step 3.
NO -
Reinstall the wheel speed sensor, and check the mounting position Service and Repair.
3. Inspect the appropriate magnetic encoder for damage, debris, and correct installation.
Is the magnetic encoder OK?
YES -
Go to step 4.
NO -
Remove the debris from the magnetic encoder, or replace the wheel bearing (front) or the hub bearing unit (rear):
- Front: Replace the front wheel bearing.
- Rear: Replace the rear hub bearing unit.
4. Disconnect the VSA modulator-control unit 47P connector.
5. Check for continuity between the appropriate wheel speed sensor GND terminal and the other wheel speed sensor GND terminals of the VSA modulator-control unit 47P connector (see table).
Is there continuity?
YES -
Repair a short in the wires between the appropriate wheel speed sensor and the other wheel speed sensor.
NO -
Go to step 6.
6. Substitute a known-good wheel speed sensor Service and Repair.
7. Reconnect all connectors.
8. Turn the ignition switch to ON (II), or press the engine start/stop button to select the ON mode.
9. Clear the DTC with the HDS.
10. Turn the ignition switch to LOCK (0), or press the engine start/stop button to select the OFF mode.
11. Test-drive the vehicle at 19 mph (30 km/h) or more.
NOTE: Drive the vehicle on the road, not on a lift.
12. Check for DTCs with the HDS.
Is DTC 12, 14, 16, or 18 indicated?
YES -
Go to step 13.
NO -
Replace the original wheel speed sensor Service and Repair.
13. Update the VSA modulator-control unit if it does not have the latest software Testing and Inspection.
14. Turn the ignition switch to LOCK (0), or press the engine start/stop button to select the OFF mode.
15. Test-drive the vehicle at 19 mph (30 km/h) or more.
NOTE: Drive the vehicle on the road, not on a lift.
16. Check for DTCs with the HDS.
Is DTC 12, 14, 16, or 18 indicated?
YES -
Check for loose terminals in the VSA modulator-control unit 47P connector. If the VSA modulator-control unit was updated and the symptom/indication is still present, replace the VSA modulator-control unit Service and Repair.
NO -
If the VSA modulator-control unit was updated, troubleshooting is complete. If any other DTCs are indicated, go to the indicated DTCs troubleshooting.