64-1
VSA DTC Troubleshooting: 64
DTC 64:
Sensor Power Source Voltage Malfunction (Without SH-AWD)
NOTE: Before you troubleshoot, record all freeze data and any on-board snapshot, and review the general troubleshooting information Reading and Clearing Diagnostic Trouble Codes.
1. Turn the ignition switch to ON (II), or press the engine start/stop button to select the ON mode.
2. Clear the DTC with the HDS.
3. Turn the ignition switch to LOCK (0), or press the engine start/stop button to select the OFF mode.
4. Test-drive the vehicle at 19 mph (30 km/h) or more.
NOTE: Drive the vehicle on the road, not on a lift.
5. Check for DTCs with the HDS.
Is DTC 64 indicated?
YES -
Go to step 6.
NO -
Intermittent failure, the system is OK at this time. Refer to intermittent failures troubleshooting.
6. Turn the ignition switch to LOCK (0), or press the engine start/stop button to select the OFF mode.
7. Disconnect the steering angle sensor 5P connector Service and Repair.
8. Disconnect the VSA modulator-control unit 47P connector.
9. Check for continuity between VSA modulator-control unit 47P connector terminal No. 5 and body ground.
Is there continuity?
YES -
Repair a short to body ground in the wire between the VSA modulator-control unit and the steering angle sensor.
NO -
Go to step 10.
10. Reconnect all connectors.
11. Update the VSA modulator-control unit if it does not have the latest software Testing and Inspection.
12. Turn the ignition switch to LOCK (0), or press the engine start/stop button to select the OFF mode.
13. Test-drive the vehicle at 19 mph (30 km/h) or more.
NOTE: Drive the vehicle on the road, not on a lift.
14. Check for DTCs with the HDS.
Is DTC 64 indicated?
YES -
Check for loose terminals in the VSA modulator-control unit 47P connector. If the VSA modulator-control unit was updated and the symptom/indication is still present, replace the VSA modulator-control unit Service and Repair.
NO -
If the VSA modulator-control unit was updated, troubleshooting is complete. If any other DTCs are indicated, go to the indicated DTCs troubleshooting.