DTC Troubleshooting

DTC Troubleshooting: P0973 (7-3)

DTC P0973:

Short in Shift Solenoid Valve A Circuit

NOTE:

- Before you troubleshoot, record all freeze data and any on-board snapshot with the HDS, and review the General Troubleshooting Information How to Troubleshoot the A/T System.
- This code is caused by an electrical circuit problem and cannot be caused by a mechanical problem in the transmission.
- If DTC P0973 is stored in the PCM, the transmission does not shift to 2nd or 5th gear because of the fail-safe function.

1. Turn the ignition switch to ON (II), or press the engine start/stop button to select the ON mode.

2. Clear the DTC with the HDS.

3. Start the engine in P, and wait for at least 1 second.

4. Check for Pending or Confirmed DTCs with the HDS.

Is DTC P0973 indicated?

YES -

Go to step 5.

NO -

Intermittent failure, the system is OK at this time. Check for poor connections and loose terminals between shift solenoid valve A and the PCM.

5. Turn the ignition switch to LOCK (0), or press the engine start/stop button to select the OFF mode.

6. Check for a blown No. 10 (10 A) fuse in the driver's under-dash fuse/relay box.

Is the No. 10 (10 A) fuse OK?

YES -

Go to step 7.

NO -

Repair a short to body ground in the wire between PCM connector terminal A1 and the driver's under-dash fuse/relay box.

7. Jump the SCS line with the HDS.

8. Disconnect PCM connectors A (49P).

9. Turn the ignition switch to ON (II), or press the engine start/stop button to select the ON mode.

10. Measure the voltage between PCM connector terminals A1 and body ground.





Is there battery voltage?

YES -

Go to step 11.

NO -

Repair an open in the wire between PCM connector terminal A1 and the driver's under-dash fuse/relay box.

11. Turn the ignition switch to LOCK (0), or press the engine start/stop button to select the OFF mode.

12. Disconnect the shift solenoid valve A connector.

13. Turn the ignition switch to ON (II), or press the engine start/stop button to select the ON mode.

14. Clear the DTC with the HDS.

15. Start the engine in P, and wait for at least 1 second.

16. Check for Pending or Confirmed DTCs with the HDS.

Is DTC P0973 indicated?

YES -

Go to step 17.

NO -

Faulty shift solenoid valve A. Replace the secondary valve body (shift solenoid valve A) Secondary Valve Body Replacement (A/T).

17. Turn the ignition switch to LOCK (0), or press the engine start/stop button to select the OFF mode.

18. Jump the SCS line with the HDS.

19. Disconnect PCM connector C (49P).

20. Check for continuity between PCM connector terminals C20 and body ground.





Is there continuity?

YES -

Repair a short to body ground in the wire between PCM connector terminal C20 and shift solenoid valve A connector terminal No. 2.

NO -

Replace the PCM Service and Repair.