Power Lumbar Support Motor Test

Power Lumbar Support Motor Test

NOTE: SRS components are located in this area. Review the SRS component locations Locations, and precautions and procedures Service and Repair before doing repairs or servicing.

1. Turn over the driver's seat-back cover/pad as needed.

2. Remove the lumber support motor cover (A).





3. Disconnect the 2P connector (B) from the lumbar support motor (C).

4. Test the motor by applying battery power and body ground to the terminals.





5. If the motor does not run or fails to run smoothly, replace it Front Seat Lumbar Support Replacement.